headerheaderheaderheaderheaderheaderheaderheader
header
headerheaderheaderheaderheaderheaderheaderheaderheaderheaderheader
header
Connector pinouts:

picture

MIDI connector MINI-DIN to 3 x Atari DIN (PDF 84kB)







picture
DIP switch from left (1) to right (6) in its on (up) positions
• DIP switches and TOS versions

1: Flash ROM write protect
2: CF-Socket is the master drive
3 + 4: to PIC (not used yet)
5 + 6: to MCF:
-) Run FireTOS (DIP switch No. 5 up, No. 6 up)
-) Run EmuTOS in fully ColdFire native mode (DIP switch No. 5 down, No. 6 up)





• PIC-Pinheader

There are different PIC programming devices that can be used for the FireBee´s PIC; they all have different pin mappings. Please take care that you use a cable with the correct connections:

picture
USB PIC PROGRAMMER

picture
PICkit2 (picture from PICkit2 pdf manual)



FireBee pinheader | USB PIC Programmer
------------------|-------------------
1 GND | GND 1
2 PGC | CLK 3
3 PGD | DAT 4
4 MCLR | VPP 6
5 PGM | LOW 5
6 VBAT | VCC 2






FireBee pinheader | PICkit2
------------------|---------
1 GND | GND 3
2 PGC | PGC 5
3 PGD | PGD 4
4 MCLR | VPP 1
5 PGM | AUX 6
6 VBAT | VDD 2






• LEDs

The pinout for the LEDs is the following:

1) JTAG-FPGA, P8 Pin 2: GND, Pin 4: 3V3 (100 Ohm resistor needed)
2) HD-LED, P17, Pin 1: 3V3, Pin 2: RDY

Preconfigured LEDs need to be connected with the blue or black cable looking to the right side (to the battery).




• Speaker:

Pin 1: Signal
Pin 2: GND
Latest News
HTTP 521 Webserver is down - Hardware failure at firebee.org
2021-03-22:
Maybe you have already noticed it: Some news, pages and downloads are no longer available. ...
Read more
GFA Basic Editor (GBE) v3.7 Released
2021-01-18:
For those not aware, the original author of GFA Basic passed away in 2011. December ...
Read more
New AHCC version released
2020-12-03:
After almost 3 years, Henk Robbers released version 6.0 of AHCC on November 27, 2020. ...
Read more
RSS Feed | Terms of Use | Sitemap